XTRA DIMENSION 3.7L UPDATE

To download the file:

Click on the link in the table below.


When prompted, specify save to disk


Then supply the destination path and click on OK and the transfer will then begin. Make sure you put all the files in the same place.

Before you do the next step of the update you should run the config.exe program located in the XTRAD directory (the one with XTRA Dimension already installed) and make a note of the settings. It would also be a good idea to backup the directory so that you can easily get back to a working system if something should go wrong.

Copy the file to the XTRAD directory on the target PC.

You should then run it and the files will be automatically extracted.

Once the files are updated make sure you run the new config.exe program and set up the parameters before you run the new xtrad.exe.

You will also need to ensure that your Texture Analyser has a firmware version greater than 5.16 but less than 6.0. If you need the firmware updated then email tech.support@stablemicrosystems.com and include the serial number of the TA and your full mailing address so we can send the EPROM to you.